CONTROL

    Standard
    ipot ixsph ifms ipaths igenfmt iff2x

The CONTROL card lets you run one or more of the modules separately. There is a switch for each module: 0 means not to run that module, 1 means to run it. You can do the whole run in sequence, one module at a time, but you must run all modules sequentially. Do not skip modules: CONTROL 1 1 1 0 0 1 is incorrect. The default is CONTROL 1 1 1 1 1 1, i.e. run all 6 modules.
  * example 1
  * calculate self consistent potentials, phase shifts and fms only
  CONTROL  1 1 1 0 0 0   ipot  ixsph  ifms   ipaths  igenfmt  iff2x

  * example 2
  * run paths, genfmt and ff2x; do not run pot, xsph, fms
  * this run assumes previous modules have already been run and
  * adds MS paths between rfms  and rpath to the MS expansion
  CONTROL  0 0 0 1 1 1    ipot  ixsph  ifms   ipaths  igenfmt  iff2x